ANTHEM D2V

Fully featured 7.1-channel audio and video processor, eight HDMI inputs,
Dolby TrueHD, DTS-HD Master Audio, PCM 24/192, highest quality 1080p
upscaling with 1080p24 compatibility, Anthem Room Correction, premium
quality A/D and D/A converters, 24-bit/192 kHz upsampling on all
channels in main zone, two stereo zones.

VIDEO SWITCHING
Bandwidth from input to output jack (bypass mode for component video)
Composite and S-Video     70 MHz
Component     Y     110 MHz
Pr     90 MHz
Pb     80 MHz
All analog video inputs and outputs are 75 Ω, 1.5 Vp-p.
ANALOG AUDIO
Input Impedance     20 kΩ
Output Impedance     Main-RCA     300 Ω
XLR     600 Ω

Zones 2/3 and Record     51 Ω
Rated Input     2.0 Vrms
Maximum Input     5.3 Vrms
Minimum Load     5 kΩ
Rated Output (100 kΩ load)     2.0 Vrms
Maximum Output     RCA     6.3 Vrms
XLR     12.6 Vrms
Headphone Output     100 mW into 32 Ω at 0.2% THD+N
Volume Control Range     Main     - 95.5 dB to +31.5 dB (in 0.5 dB increments)
Zone 2/3 and Headphone     - 62.5 dB to +10.0 dB (in 1.25 dB increments)
Crosstalk (at 1 kHz)     82 dB between channels; 86 dB between inputs
XLR Pin Configuration     Pin 1: Ground, Pin 2: Positive, Pin 3: Negative
DIGITAL AUDIO
Crossover     High-Pass Slope (small speaker setting)     12 dB/octave (2nd order)
Low-Pass Slope (subwoofer)     24 dB/octave (4th order)
Frequency (adjustable)     25 Hz to 160 Hz (in 5 Hz increments)
Tone Control     Fliter Type     Shelf
Range     +/- 12 dB
Bass Turnover Frequency     200 Hz
Treble Turnover Frequency     2 kHz
Analog-to-Digital Conversion S/N Ratio (at digital Rec output) (IEC-A Filter)     100 dB
All digital audio inputs and outputs comply with HDMI, S/PDIF or AES/EBU standards. Sample rate converter output is 24 bit/192 kHz regardless of input.
MAIN PATH (RCA and XLR Outputs)
Frequency Response and Bandwidth     Analog Direct Inputs     10 Hz to 20 kHz (+0 -0.2 dB), 1 Hz to 130 kHz (+0 -3 dB)
Analog-DSP Inputs at 24/96     10 Hz to 20 kHz (+0 -0.3 dB), 2 Hz to 44.1 kHz (+0 -3 dB)
Digital Inputs at 24/96     10 Hz to 20 kHz (+0 -0.2 dB), 1 Hz to 45 kHz (+0 -3 dB)
THD+N (at Rated Input and Output)     Analog Direct Inputs     0.006% (80 kHz BW)
Analog-DSP Inputs at 24/48 or 24/96     0.004% (AES17 Filter)
Digital Inputs at 24/48 or 24/96     0.004% (AES17 Filter)
IMD (CCIF at 15 kHz and 16 kHz)     Analog Direct Inputs     <0.001%
Analog-DSP Inputs at 24/48     0.001%
Digital Inputs at 24/48 or 24/96     0.001%
S/N Ratio (ref. 2.0 Vrms, IEC-A Filter)     Analog Direct Inputs     107 dB
Analog-DSP Inputs at 24/48 or 24/96     101 dB
Digital Inputs at 24/48 or 24/96     104 dB
ZONE 2 and ZONE 3 PATHS
Frequency Response and Bandwidth     20 Hz to 20 kHz (+0 -0.1 dB), 3 Hz to 140 kHz (+0 -3 dB)
THD+N (at Rated Input and Output)     0.06% (80 kHz BW)
IMD (CCIF at 15 kHz and 16 kHz)     0.06%
S/N Ratio (ref. 2.0 Vrms, IEC-A Filter)     97 dB
FM TUNER
Sensitivity     50 dB S/N     13 dBµ typical, 25 dBµ max.
IHF     10 dBµ typical, 20 dBµ max.
S/N Ratio     Mono     75 dB typical, 65 dB min.
Stereo     69 dB typical, 60 dB min.
Distortion     Mono     0.2% typical, 1.0% max.
Stereo     0.3% typical, 1.5% max.
Stereo Separation     40 dB typical, 25 dB min.
Alternate Channel Selectivity (+/- 400 kHz)     70 dB typical, 60 dB min.
Frequency Response     25 Hz to 15 kHz (+0 -2 dB)
AM TUNER
Sensitivity (20 dB S/N)     49 dBµ typical, 56 dBµ max.
S/N Ratio     50 dB typical, 43 dB min.
Distortion     0.7% typical, 2.0% max.
One-Signal Selectivity (+/- 10 kHz)     24 dB typical, 18 dB min.
CONTROL
Infra Red     Carrier Frequency     38 kHz
Maximum 12 V Supply Current     150 mA
Maximum Emitter Current     60 mA per output
RS-232 Interface     Connection     DB-9F, straight-wired
Pinout (D2v side)     Pin 2: Tx, Pin 3: Rx, Pin 5: Ground
Baud Rate     1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200


Configuration
8 data bits, 1 stop bit, no parity bits, flow control (RTS/CTS, none)
Trigger Outputs     Polarity     tip positive, sleeve ground
Maximum Current at 12 VDC     300 mA between all three triggers
Sequential Delay     250 ms
POWER REQUIREMENT
Consumption     Maximum 170 W
DIMENSIONS
Height     5-7/8 inches (14.9 cm) including feet;
rack-mounting: 3 rack units without feet
Width     Standard version     19-1/4 inches (49 cm)
Rack-Mount version     19 inches (48.3 cm)
No-Handle version     17-1/4 inches (43.8 cm)
Depth     15-1/4 inches (38.7 cm)
Weight (unpacked)     27 lb (12.3 kg)